Philips NP2500 User manual - Page 14

• Manual entry of your encryption key (for encrypted network connections only) • First-time setup: Wired (Ethernet) network connection with automatic IP address This setup requires the following: • A wired access point or wired router with broadband Internet access and a free Ethernet port • An Ethernet cable (sold separately). • First-time setup: Wired (Ethernet) network connection with static IP address This setup requires the following: • A wired access point or wired router with broadband Internet access and a free Ethernet port • Manual entry of your IP address. • An Ethernet cable (sold separately). First-time setup:Wireless connection with automatic IP address This is how to navigate and select with the remote control: • Press or to select a menu option. • Press OK to confirm a selection. • Press BACK to go back to the previous screen. • Press HOME to go to the Home menu. The alphanumeric buttons of the remote control are multi-function buttons: • To select a number or an alphanumeric character, press a button once or repeatedly until you see the number or alphabetic character in the display of NP2500. • To cycle through the alphanumeric characters that are available, press a button repeatedly. • To delete the last character entry from the display, press CLEAR. • To delete the whole last line entry from the display, press and hold CLEAR. The onscreen display guides you through the process of connecting NP2500 to your home network and the Internet. This section describes the typical wireless setup with automatic IP address. You can also follow the onscreen prompts for advanced configurations that are not described in this manual. 1 Ensure that your network name and network password or encryption key are available. 2 Turn on your wireless access point or wireless router with broadband Internet access. 3 Follow the steps in chapter First-time connection to home network until NP2500 shows the prompt for the network setup. 4 Select [Wireless (WiFi)] to start the network setup process. • For wireless routers with Wi-Fi protection system (WPS) that supports push button configuration (PBC): On the router, press the WPS PBC push button to activate. On NP2500 press OK to confirm.) • For wireless routers with Wi-Fi protection system (WPS) that supports a personal identification number (PIN): On NP2500 select WPS PIN, then enter the displayed PIN on the router. • For other wireless routers: »» NP2500 searches for networks. 1 Select your network from the list of found networks and confirm. • Enter the encryption key (if required) and confirm. • NP2500 acquires the automatic IP address. • NP2500 shows the confirmation for the connection to the network. • NP2500 shows the prompt for the connection to the Internet. EN 13 English