Philips SDV8625T/27 User Manual - Page 10
Set up a digital tuner with this, antenna, Connect to the TV - digital tv antenna
View all Philips SDV8625T/27 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Warning •• The power injector and power supply are for indoor use only. Tip •• This antenna includes a 19.7ft roll of 3C-2V coaxial cable. If this is not adequate for your needs, replace the cable with a RG-6 coaxial cable instead of adding an extension. Connect to the TV Note •• As previously noted, the amplifier (Power injector + Power supply) must be placed inline between the antenna and any splitter or additional devices. 1 Connect the coaxial cable from the antenna to the connector labeled ANT on the power injector . 2 Connect the power injector to the antenna input on the TV, digital set-top box, splitter or other devices. 3 Connect the power supply plug to the power injector , and then plug the power supply adaptor into a 100-240V AC receptacle. 10 EN Set up a digital tuner with this antenna You can install available channels with the digital TV tuner.This automatic process is part of the setup of the tuner. Ensure the antenna has set up properly before the tuner can receive viewable channels. There are two ways to connect the antenna to the TV: • Connect the antenna to a digital tuner. If the signal strength is good enough, the channels can be memorized in the tuner automatically . • Connect the antenna directly to the TV. Tune to the analogue channels and find the best antenna location. Then reconnect the antenna to the digital tuner. Ensure the signal strength is good enough before you install the channels with the tuner.