Philips SHB6000/28 User manual - Page 7

3 Get started Charge the headset Warning •• Before you use your headset for the first time, charge the battery for four hours for optimum battery capacity and lifetime. •• Use only the original USB charging cable to avoid any damage. •• Finish your call before charging the headset, as connecting the headset for charging will power off the unit. •• You can operate the headset normally during charge. 1 Remove the USB cap. 2 Plug the headset into a powered USB port with USB charging cable. »» LED turns red during charge and turns off when the headset is fully charged. Pair the headset with your mobile phone Before you use the headset with a mobile phone for the first time, pair it with the mobile phone. A successful pairing establishes a unique encrypted link between the headset and the mobile phone. The headset stores the last three links in the memory. If you try to pair more than three devices, the link for the earliest paired device is overwritten. 1 Ensure that the mobile phone is turned on and its Bluetooth feature is activated. 2 Ensure that the headset is charged and turned off. 3 Press until the LED starts flashing red and blue alternately. Do not stop pressing the button after seeing the blue LED only. »» The headset is in pairing mode, which lasts five minutes. 4 Pair the headset with the mobile phone. For details, refer to the user manual of the mobile phone. A sample pairing is shown below. 1 Under Bluetooth menu on the mobile phone, search for the headset. 2 On mobile phones using Bluetooth 2.1 or higher, you do not need to enter a pass code. 3 From the found devices, select Philips SHB6000. • Enter "0000" (4 zeros), if prompted to enter the pin code of the headset. Settings Bluetooth 10:35 Connectivity Add Bluetooth device Select Back 10:36 Settings Devices Found Philips SHB6000 Select Back Settings 10:37 Connectivity Enter Password **** 0000 Select Back Tip •• Typically, a full charge takes two hours. 6 EN