Philips US2-PM725S User manual - Page 6

PM725.manual 5/27/08 9:23 AM Page 10 Code Entry DIRECT CODE ENTRY 1. Press and hold the Code Search button until the red indicator stays on. Release the Code Search button. 2. Press and release the desired mode button (TV, VCR, etc.). The red indicator blinks, then stays lit. 3. Enter the 3 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashe s. 4. With your device on, press CHANNEL Up. If the device responds, no further programming is required. Note: If some buttons do not operate your equipment, try one of the other codes for your brand. 2. 4. 1. 3. Write your codes down here for easy reference later. PROGRAMMING WITH CODE SEARCH 1. Manually turn on the device (TV, VCR, etc.) to be controlled. 2. P ress and hold Code Search button until the red indicator stays on. Release the Code Search button. 3. P ress and release the desired mode button (TV, VCR, etc.). The red indicator blinks, then stays lit. 4. Press the Channel Up button repeatedly (up to 300 times) until the device to be controlled changes channel. The red indicator blinks, then stays lit. If you accidentally overshoot the code required, press the Channel Down button to backtrack through the library until the device changes channel. Pressing Channel Up changes direction to forward again. Press and release the Mute button to install the code. The above assumes that you want to store VCR codes under the VCR button, Cable codes under CBL, etc. If you want to store a VCR code under CBL, etc., first follow the procedure on page 10 and try ANY CBL code from the code tables, e.g. press CBL in step 2, page 10, and then enter ANY VCR code. Then follow the steps above. Note: If the device does not have a Channel Up button,use Play (VCR only) or Power instead. Code Search starts from the currently stored three digit number under that mode e.g. if the mode has 100 codes and the currently stored code is 050 then the Code Search starts from 051 continuing to 100 before looping back to 000 and finishing at 050. This simplifies the process if you find that several preprogrammed codes operate your device by allowing you to bypass codes already tried. 4. 1., 3. 2. 1 0 1 1