Pioneer 6010FD Owner's Manual - Page 22
Bundle the cables. - pdp mount
UPC - 012562864907
View all Pioneer 6010FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
05 Preparation When using the hung on wall unit (PDP-6010FD) Note • First lay the plasma display on top of a soft sheet etc., remove the stand, then attach the speaker mounting fittings. • Install the plasma display on the wall with only the speaker mounting fittings and speaker cable attached to the display, and then attach the speaker. (See page 19) • To facilitate attachment of wiring, it is recommended to complete the wiring on the sides of the plasma display before mounting speaker to the display. Caution • Be careful about the speaker mounting fittings when installing or connecting. This may result in injury. 1 Connect the supplied speaker cables to the back of the plasma display. 2 Place the plasma display on the mounting fittings of the hung on wall unit. For details, refer to the instruction manual supplied with the hung on wall unit. 3 Connect the other end of the speaker cables to the speaker. 4 Place the speaker on the speaker mounting fittings in the correct direction. 5 Tighten using the supplied screws (four locations). • Tighten the four screws in order , , , as shown in the drawing. The screw hole at the rear surface of the speaker mounting fitting is used when the plasma display is installed with the table top stand. It is not used when installed on the wall. Note • If after attaching the speaker its position needs to be adjusted horizontally, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position. 6 Bundle the cables. • Bead bands are included with the plasma display. • Use the bead bands as necessary. • When tidying up your speaker cables, make sure to bundle them so that they are not subjected to any pressure. Speaker mounting screw (M5 x 10 mm) 4 Speaker mounting screw (M5 x 10 mm) 2 1 When using the hung on wall unit, do not use these holes. 22 En 3 Speaker mounting screw (M5 x 10 mm)