Pioneer AVH-X1600DVD Owner's Manual - Page 50
Connecting the power cord, Connection, Function of AVH-X5600BHS/AVH-X4600BT/AVH-X3600BHS/AVH-X2600BT
View all Pioneer AVH-X1600DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Section 26 Connection Connecting the power cord Pioneer Add-on Navigation system (sold separately) 26 pin cable (Supplied with navigation unit) Insert the 26 pin cable in the direction indicated in the figure. RGB input Please contact your dealer to inquire about the connectable navigation unit. This product Antenna input Fuse (10 A) AUX jack (3.5 ø) Use a mini plug cable to connect with auxiliary device. Yellow Connect to the constant 12 V supply terminal. Orange/white Connect to lighting switch terminal. Red Connect to terminal controlled by ignition switch (12 V DC). Black (chassis ground) Connect to a clean, paint-free metal location. Front speaker Left Rear speaker or Subwoofer (4 Ω) White Gray White/black Green Gray/black Violet Green/black Violet/black Front speaker Right Rear speaker or Subwoofer (4 Ω) When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit. Do not connect anything to Green and Green/black leads. Green Not used. Green/black Violet Violet/black Subwoofer (4 Ω) × 2 50 En Connection 4 m (13 ft. 1 in.) Microphone (Function of AVH-X5600BHS/AVH-X4600BT/AVH-X3600BHS/AVH-X2600BT) Microphone input (Function of AVH-X5600BHS/AVH-X4600BT/AVH-X3600BHS/AVH-X2600BT) Wired remote input Hard-wired remote control adapter can be connected (sold separately). Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. Power supply side Ground side Blue/white Connect to system control terminal of the power amp or auto-antenna relay control terminal (max. 300 mA 12 V DC). Parking brake switch With a 2 speaker system, do not connect anything to the speaker leads that are not connected to speakers. Note: · Change the initial setting of this unit. The subwoofer output of this unit is monaural.