Pioneer AVH-X3500BHS Owner's Manual - Page 56
Understanding auto EQ error, messages, Understanding messages, Additional information - amp error
View all Pioneer AVH-X3500BHS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Appendix Additional information Additional information Message Cause Action Start up the Pandora Application from your Device. The Pandora ap- Start up the plication has Pandora applica- not started run- tion from your ning yet. iPhone. Unable to save thumb rating. Try again later. Unable to save thumb rating. Try again later. Unable to save Bookmark. Try again later. Unable to save Try again later. Bookmark. Pandora system maintenance. Try again later. Pandora system is undergoing maintenance. Try again later. Skip limit reached. Skip limit reached. Do not exceed the skip limit. This version of the Pandora Application is not supported. This version of the Pandora application is not supported. Connect an iPhone that has a compatible version of the Pandora application installed. Check Device Device error message displayed in the Pandora application. Please check your iPhone. Pandora is unable to play music. Please see your Device. Unable to play music from Pandora. Please check your iPhone. Message Cause Action Create station within the Pandora Application on Device. No station found. Create a station in the Pandora application on your iPhone. No Active Station No station se- Select a station. lected. Communication error occured. Please reconnect your device. If there is no ACK after 10 attempted retries at 750 ms, the accessory should assume that communication is interrupted and disconnect from PandoraLink. Please reconnect your iPhone and try again. Device has not been registered. Go to Bluetooth Connection Menu to register. No Bluetooth device found. Follow the instructions that appear on the screen. BT error. Press BAND key to retry. Bluetooth connection failed. Follow the instructions that appear on the screen. Start up Pandora. Press BAND key to retry. Connection to the Pandora application failed. Follow the instructions that appear on the screen. Check Pandora. Press BAND key to retry. Connection to the Pandora application failed. Follow the instructions that appear on the screen. 56 En Message Cause Action Disconnected.Press BAND key to retry. Bluetooth connection lost. Follow the instructions that appear on the screen. Understanding auto EQ error messages When correct measurement of the car's interior acoustic characteristics is not possible using auto EQ, an error message may appear on the display. In such cases, refer to the table below to see what the problem is and how it may be corrected. After checking, try again. Message Cause Action Error. Please check noise. Error. Please check battery. The surrounding noise level is too high. ! Stop your car in a place that is quiet, and switch off the engine, air conditioner and heater. ! Set the microphone correctly. Power is not being supplied from the battery to this unit. ! Connect the battery correctly. ! Check the battery voltage. Understanding messages Message Cause Action Please con- The microphone Plug the optional nect the mi- is not con- microphone se- crophone for nected. curely into the measure- jack. ment. When finished, please push HOME key. Error. Please check xxxx speaker. The microphone ! Confirm that cannot pick up the speakers are the measuring connected cor- tone of a speak- rectly. er. ! Correct the input level setting of the power amp connected to the speakers. ! Plug the micro- phone securely into the jack. Messages Screen image may appear reversed. Translation Pioneer recommends the use of a camera which outputs mirrorreversed images. Otherwise, the screen image will appear reversed.