Pioneer AVIC-X850BT Operation Manual - Page 172
Messages for navigation functions, Appendix
View all Pioneer AVIC-X850BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Appendix Appendix Messages for navigation functions The following messages may be displayed by your navigation system. Refer to the table to identify the problem, then take the suggested corrective action. There are occasions when you may see error messages other than those shown here. In such cases, follow the instructions given on the display. Message Cause Action (Reference) Route calculation was not possible. Route calculation has failed because of a malfunction in the map data, software, or hardware. ! Change the destination. ! Consult the Pioneer Local dealer if this message persists. Route calculation not possi- The destination is too far. ble. Destination too far. Set a destination closer to the starting point. Route calculation not possi- The destination is too close. ble. Destination too close. Set a destination farther from the starting point. Route calculation not possi- The destination, waypoint(s), or ! Set a destination and waypoint(s) on roads. ble. Navigation cannot be pro- starting point are in an area where ! Reset the destination after you drive the ve- vided around destination or no road exists (e.g. a mountain) and hicle to any road. starting point. the route calculation is impossible. Unable to find any road leading to the destination. The destination or waypoint(s) are in Change the destination. an isolated island, etc. without a ferry and the route calculation is impossible. If there is no road connected to your starting point or destination, this message will appear. Failed to create route profile In rare cases, a route calculation error may occur. ! Retry. ! Consult the Pioneer Local dealer if this message persists. No image file. "Pictures" folder exists on the SD memory card but there is no loadable data in the folder. Use appropriate data and store it correctly. (Page 146) Unsupported file format. An image file was not made to spe- Use appropriate data and store it correctly. cifications as the splash screen. (Page 146) Abnormal status on speaker connection or main unit was detected. If it does not return to normal status after ACC off/on, consult Pioneer authorized dealer or Pioneer service. This unit fails to operate or the speaker connection is incorrect; the protective circuit is activated. Check the speaker connection. If the message fails to disappear even after the engine is switched off/on, contact your dealer or an authorized Pioneer Service Station for assistance. 172 En