Pioneer AVX-7000 Manual - Page 15

Closing the Display

Get Pioneer AVX-7000 PDF manuals and user guides View all Pioneer AVX-7000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Closing the Display The display will be automatically closed by the automatic close/open mode. If the display does not close automatically, press the OPEN/CLOSE button. • When closing the display, check to make sure that it has closed completely. If the display has stopped halfway, leaving it like this could result in damage to it. • The automatic close/open mode will operate the display as follows. * When the ignition switch is turned OFF while the display is deployed, the display will be closed after approximately 6 seconds. When the ignition switch is turned ON again (or turned to ACC), the display will be deployed automatically. * Removing the front panel will close the display. (Refer to page 16.) • The automatic close/open mode can be canceled. (Refer to page 16.) • When the ignition switch is turned OFF after the display has been closed, turning the ignition switch ON again (or turning it to ACC) will not deploy the display. In this case, press the OPEN/CLOSE button to deploy the display.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
¼·
Closing the Display
²
7XUQµWKHµYHKLFOH¿VµHQJLQHµ2))¶
The display will be automatically closed by the automatic close/open mode. If the display does
not close automatically, press the OPEN/CLOSE button.
1RWH³
•
When closing the display, check to make sure that it has closed completely. If the display has stopped
halfway, leaving it like this could result in damage to it.
•
The automatic close/open mode will operate the display as follows.
*
When the ignition switch is turned OFF while the display is deployed, the display will be closed
after approximately 6 seconds.
When the ignition switch is turned ON again (or turned to ACC), the display will be deployed
automatically.
*
Removing the front panel will close the display. (Refer to page 16.)
•
The automatic close/open mode can be canceled. (Refer to page 16.)
•
When the ignition switch is turned OFF after the display has been closed, turning the ignition switch
ON again (or turning it to ACC) will not deploy the display. In this case, press the OPEN/CLOSE
button to deploy the display.