Pioneer FHD1 Owner's Manual - Page 20

06 Preparation Preparing the remote control unit Inserting batteries 1 Open the battery cover. 2 Load the supplied two AA size batteries while inserting their respective negative polarity (-) ends first. overheat, explode or catch fire. It can also reduce the life or performance of batteries. CAUTION • WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY WITH GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL PUBLIC INSTRUCTION'S RULES THAT APPLY IN YOUR COUNTRY/AREA. Allowed operation range of the remote control unit Operate the remote control unit while pointing it toward the remote control sensor ( ) located at the bottom right of the front panel of the Plasma Display. The distance from the remote control sensor must be within 7 m and the angle relative to the sensor must be within 30 degrees in the right, left, upward, or downward direction. • Place batteries with their terminals corresponding to the (+) and (-) indicators in the battery compartment. 3 Close the battery cover. 30º 7 m 30º Remote control sensor Cautions regarding the remote control unit Cautions regarding batteries Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below. • When you replace the batteries, use manganese or alkaline ones. • Place the batteries with their terminals corresponding to the (+) and (-) indicators. • Do not mix batteries of different types. Different types of batteries have different characteristics. • Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries. • Remove batteries as soon as they have worn out. Chemicals that leak from batteries can cause a rash. If you find any chemical leakage, wipe thoroughly with a cloth. • The batteries supplied with this product may have a shorter life expectancy due to storage conditions. • If you will not use the remote control unit for an extendedperiod of time, remove the batteries from it. • Do not expose the remote control unit to shock. In addition, do not expose the remote control unit to liquids, and do not place in an area with high humidity. • Do not install or place the remote control unit under direct sunlight. The heat may cause deformation of the unit. • The remote control unit may not work properly if the remote control sensor of the Plasma Display is under direct sunlight or strong lighting. In such case, change the angle of the lighting or Plasma Display, or operate the remote control unit closer to the remote control sensor. • When any obstacle exists between the remote control unit and the remote control sensor, the remote control unit may not function. • As the batteries become empty, the remote control unit can function within a shorter distance from the remote control sensor. Replace the batteries with new ones early enough. • The Plasma Display emits very weak infrared rays from its screen. If you place such equipment operated through infrared remote control as a VCR nearby, that equipment may not receive commands from its remote control unit properly or entirely. If this is the case, place that equipment at a location far enough from the Plasma Display. WARNING • Depending on the installation surroundings, this unit's remote control unit may be influenced by the infrared rays • Do not use or store betteries in direct sunlight or discharged from the Plasma Display, hampering reception other excessively hot place, such as inside a car or of its rays or limiting its operational distance. The strength of near a heater. This can cause batteries to leak, infrared rays discharged from the screen will differ according to the picture displayed. 20 En