Pioneer HTP-4600 Owner's Manual - Page 1

HTP-4600 Quick Start Guide 1 Check that you have all the accessories. Insert the supplied batteries following the markings inside the battery compartment to align them correctly. AM loop antenna Batteries (x2) FM wire antenna STANDBY/ON MUTE SLEEP STATUS DIMMER INPUT SELECTOR TUNER DIGITAL STB DVD/DVR EDIT FM/AM TAPE/VCR TV CLASS TUNING -+ STATION -+ SYSTEM SETUP VOLUME CH LEVEL + ROOM SETUP AUTO ENTER TEST TONE - SURROUND STEREO OFF SOUND TONE MPX BASS -+ TREBLE -+ RECEIVER Remote control You should also have: • Speakers* • Subwoofer • Non-skid pads (1x12) • Speaker cord (x6) • AC adaptor • Transmitter • Power cord • RCA stereo cord • Safety precautions (1 sheet) • Operating instructions • Warranty card * Before placing the speakers, please refer to the speaker manual for detailed assembly instructions. Also check the speaker manual for a complete list of supplied accessories. 2 Connect wireless speaker transmitter. 1 Use the supplied 2-pin RCA cord to connect the WIRELESS (IN) jack on the transmitter to the WIRELESS (OUT) jack on the rear panel of the receiver. 2 Connect to a power outlet using the supplied AC adaptor. Transmitter IN R L WIRELESS AC adaptor To power outlet Receiver WIRELESS OUT L R SPEAKERS FRONT R L CENTER SUB WOOFER SURROUND RL WIRELESS + + OUT L - -R 3 Connect each speaker to the receiver using the supplied speaker wires. To connect, insert the colored wire into the matching colored (+) tab and the other wire into the black (-) tab as shown below. Note that the color-coded tabs are as follows: • Red : Front right speaker • White : Front left speaker • Green : Center speaker • Purple : Subwoofer • Grey : Surround right speaker • Blue : Surround left speaker IN R L WIRELESS Transmitter Receiver SPEAKERS FRONT R L CENTER SUB WOOFER SURROUND R L WIRELESS + + OUT L - -R Surround right Wireless speaker Surround left • Please also read the Operating Instructions included with the wireless speaker. Listening position Subwoofer For the best surround sound, set up your speakers like this. The front left and right speakers should be about 6-9 feet apart. Front right Center Front left 4 Connect antennas 1 Connect the FM wire antenna and fully extend along a window frame or another suitable place that gives good reception. 2 To connect the AM loop antenna, twist the exposed wire strands together and insert into the terminal, then snap the connector shut as shown below. AM loop antenna FM wire antenna ANTENNA FM UNBAL 75Ω AM LOOP Receiver 5 Connect the receiver to your DVD player/ recorder. 1 Use a coaxial digital cord (not supplied) to connect the digital output of your DVD player/ recorder to the DIGITAL INPUT (COAXIAL) DVD/DVR jack. 2 Use a red/white stereo audio cord (not supplied) to connect the AUDIO TV IN jack on the receiver to the audio output on your TV.* This will allow you to listen to your TV through this speaker system. * Note that you must also connect the DVD player/ recorder's video output to your TV's video input to watch a DVD video (video cable is not supplied). DIGITAL INPUT (COAXIAL) DVD/DVR AUDIO TV IN IN OUT R L + + - - Receiver 6 Plug the receiver, wireless speaker, DVD player/ recorder and TV into a convenient AC outlet. 1 Press STANDBY/ON to switch on the receiver. STANDBY/ON STANDBY/ON Receiver 2 Press to switch the wireless speaker on. Wireless speaker TUNED POWER OFF ON POWER OFF ON 7 After switching on, make any necessary settings required by the DVD player/ recorder, then you're ready to start enjoying your home theater system. Refer to the receiver's operating instructions for a detailed explanation of this system's surround sound features. VOLUME + - AUTO SURROUND STEREO INPUT SELECTOR DIGITAL STB DVD/DVR FM/AM TAPE/VCR TV 3/8 in. (10mm) DVD player/ recorder DIGITAL OUT VIDEO OUT R L VIDEO IN AUDIO OUT TV 3 Switch on your DVD player/ recorder and TV, and set the TV to the correct video input. STANDBY/ON STANDBY/ON VIDEO 1 VIDEO SELECT DVD player/ recorder TV For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404.