Pioneer PD-F507 Owner's Manual - Page 15

TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work. Symptom No sound Probable cause ÷ Output cables are connected incorrectly or loosely. ÷ Incorrect operation of stereo amplifier. ÷ Pin plugs and/or amplifier terminals are dirty. ÷ Player is in pause mode. ÷ The disc is loaded with the label side leftward. Remedy ÷ Connect properly. ÷ Check the settings of amplifier switches and sound volume controls. ÷ Clean away dirt. ÷ Press 3 or 8. ÷ Reload the disc with the label side rightward. When playback is started, it stops immediately. Pause or stops during playback. ÷ Disc is inserted in the wrong way. ÷ Smudges, etc., on the disc. ÷ Insert the disc correctly with the label side rightward. ÷ Clean the smudges from the disc and then play it again. Remote control will not function. (PD-F507 only) ÷ Dead batteries. ÷ Obstruction between player and remote control unit. ÷ Replace batteries. ÷ Relocate remote control unit or remove obstruction. Abnormal functioning of this unit may be caused by static electricity, or other external interference. To restore normal operation, unplug the AC power cord and then plug it in again. SELF-DIAGNOSTICS FUNCTION The unit incorporates the self-diagnostic function. When an abnormality is detected during operation of the unit, an error message (service No.) appeares on the units display automatically. Treat the error by following the instructions in "Countermeasures". Display on the unit Service No. DISC TRACK MIN SEC Service No. U1 Unit Status The disc may not be loaded properly in the rack. Countermeasures ÷ Reload the discs properly. (Insert one disc only in a slot .) ÷ Check if there is a foreign object attached onto the disc. ÷ Check if there is a foreign object in the rack. U2 There is an operation error in the mechanical section. ÷ Check if there is a foreign object in the rack. ÷ Unplug the power cord then plug it in again. If the same display appears again, there may be an error in the mechanical section. When requesting servicing, please also let us know the service number displayed on the unit. SPECIFICATIONS 1. General Type Compact disc digital audio system Power requirements Flat blade 2-pin AC plug model AC 110-127V/220-240V (switchable) 50/60 Hz Power consumption 13W Operating temperature 5°C - +35°C Weight ( without package 4.8 kg External dimensions 420(W) X 312(D) X 193(H) mm 2. Audio section Frequency response 2 Hz - 20 kHz Level difference between channels 1.0 dB or less (EIAJ) Output voltage 2 ± 0.3 Vrms (EIAJ) Wow and flutter less than ±0.001 % (W.PEAK) ( below measurable level ) (EIAJ) Channels 2-channel ( stereo ) 3. Output terminal Audio line output Control input/output jacks (PD-F407 only) Optical digital output jack (PD-F507 only) 4. Accessories ÷ Remote control unit (PD-F507 only 1 ÷ Size AA/R6P dry cell batteries (PD-F507 only 2 ÷ Control cable (PD-F407 only 1 ÷ Output cable 1 ÷ CD liner notes file 1 ÷ Index label sheet 1 ÷ Operating instructions 1 NOTE: Specifications and design subject to possible modification without notice, due to improvements. TROUBLESHOOTING/SPECIFICATIONS 15 En