Polaroid DRA-01601A User Manual - Page 33
Troubleshooting Guide - power supply
View all Polaroid DRA-01601A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Troubleshooting Guide Before contacting service personnel, please check possible problems and solutions below: SYMPTOM POSSIBLE CAUSE REMEDY No power 1. Power supply disconnected 2. Bad connection between power plug and receptacle 3. Power of receptacle switched off 1. Connect to power supply 2. Plug again or replace receptacle with new one 3. Switch on receptacle No sound 1. Incorrect input connection 2. Disc is deformed or dirty 3. System is in mute status 1. Connect inputs properly 2. Clean of fix disc 3. Press "MUTE" button No picture 1. Incorrect signal connection 2. Incorrect TV status 3. TV system out mode is Progressive, but your TV system is Interlace mode 1. Connect the inputs correctly 2. Re-adjust TV/AV status 3. Press PS/IS to angle or mode No color 1. Wrong TV system selection 2. Improper color adjustment 3. Incorrect video output 1. Set up system by pressing "SYSTEM" button on remote control 2. Readjust color 3. Check for correct video output settings Disc cannot be played 1. No disc in drive 2. Disc placed incorrectly 3. Moisture condensed in unit 4. Not in playing status 5. Wrong disc format 6. Disc dirty 1. Insert disc 2. Put disc on disc tray properly with label side up 3. Leave unit on for about an hour (without disc) before using again 4. Press "PLAY" button to switch playing status 5. Please with supported disc format 6. Clean disc with soft cloth from center to edge Remote control malfunction 1. Remote control not directed at 1. Direct remote control at sensor sensor 2. Reduce receiving distance 2. Receiving distance is more than 8 3. Replace batteries meters 4. Remove obstacle 3. Low voltage in remote control batteries 4. Outside obstacle between unit and remote control Sudden malfunction 1. Bad disc quality 2. Button was pressed mistakenly 3. Outside static 1. Wait 5-10 seconds, playback will be restored 2. Turn off and restart unit 3. Shut off for 1-2 minutes and restart unit Picture dividing 1. Selected system is incompatible 1. Set up correct system with disc External signals cannot be recorded 1. Incorrect system connection 2. No disc or re-recordable disc 3. Disc has been finished 4. No free disc space 1. Connect properly 2. Insert recordable disc 3. Change disc 4. Change disc No monitor signal Timer recording cannot be done Recording aborted halfway 1. Input source not prepared 2. Incorrect video output system 3. Actual input source not consistent with selected 1. Disc does not meet requirements 2. Wrong time setting 3. Input source does not work properly during recording time 4. System power failure 1. There is no free disc space 2. Bad disc quality 1. Prepare input source 2. Switch video output system 3. Select proper input source 1. Replace with new disc 2. Set up time again 3. Ensure input source works correctly during recording time 4. Set system to standby 1. Replace with blank disc 2. Replace with high quality disc 33