Poulan PP10530ES User Manual - Page 9

OPERATION SAFETY IGNITION KEY SPARK PLUG CHOKE CONTROL ENGINE OIL CAP WITH DIPSTICK AUGER CONTROL LEVER GASOLINE FILLER CAP DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER TRACTION DRIVE CONTROL LEVER CHUTE DEFLECTOR FUEL SHUT-OFF VALVE LH TURN TRIGGER THROTTLE / ENGINE CONTROL DISCHARGE CHUTE RECOIL (AUXILIARY) STARTER HANDLE POWER CORD PLUG ELECTRIC START BUTTON PRIMER OIL DRAIN PLUG CLEAN-OUT TOOL DEFLECTOR REMOTE CONTROL LEVER LIGHT HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. MUFFLER TOOLBOX AUGERS SKID PLATE FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. Auger control lever - used to engage auger motion (throw Recoil (auxiliary) starter handle - used for starting engine. snow). Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Discharge chute control lever - used to change the direction the snow is thrown. Choke Control - used for starting a cold engine. Deflector remote control lever - used to change the distance the snow is thrown. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Skid plate - used to adjust height of scraper bar from the ground. LH and RH turn triggers - used to steer the snow thrower. 9