Poulan XT824ES User Manual - Page 8
Meets A.n.s.i. Safety Requirements, On / Off Switch
View all Poulan XT824ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
GASOLINE FILLER CAP MUFFLER CHOKE CONTROL PRIMER SAFETY IGNITION KEY ON / OFF SWITCH NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. OPERATION ELECTRIC START BUTTON AUGER CONTROL LEVER RECOIL (AUXILIARY) STARTER HANDLE CHUTE DEFLECTOR DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER TRACTION DRIVE CONTROL LEVER DISCHARGE CHUTE CLEAN-OUT TOOL LIGHT CHUTE DEFLECTOR KNOB HANDLE KNOB MUFFLER TOOLBOX SKID PLATE AUGERS FIG. 8 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. Recoil (auxiliary) starter handle - used for starting the engine. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Choke control - used for starting a cold engine. Auger control lever - used to engage auger motion (throw snow). Discharge chute control lever - used to change the direction the snow is thrown. Skid plate - used to adjust height of scraper bar from the ground. ON / OFF switch - used to STOP the engine. 8