ProForm 1200 E Elliptical English Manual - Page 10

9. Apply a small amount of grease to two Wave Washers (88) and to two Thrust Washers (66). Slide the Left Handlebar (19) onto the Handlebar Axle (16). Then, slide a Wave Washer (88) onto the end of the Handlebar Axle. Start an M8 x 19mm Button Screw (56), an M8 Small Washer (18), an Axle Cap (41), and a Thrust Washer (66) into the Left Handlebar (19). Make sure that the Thrust Washer remains on the shoulder of the Axle Cap, and that the Wave Washer (88) remains on the end of the Handlebar Axle (16). Assemble the Right Handlebar (20) in the same way. Tighten both M8 x 19mm Button Screws (56) at the same time. 9 19 16 88 66 18 56 41 Grease 20 66 56 18 88 41 Grease 1 10. Apply a small amount of grease to the barrel of an M8 x 55mm Bolt Set (92) and to two 7mm 10 Spacers (55). Have a second person hold the front end of the Left Pedal Arm (14) inside the bracket on the left Handlebar Leg (17). Attach the Left Pedal Arm (14) to the left Handlebar Leg (17) with the M8 x 55mm Bolt Set (92), two M8 Washers (69), and the two 7mm Spacers (55) as shown. Do not overtighten the Bolt Set; the left Handlebar Leg must pivot freely. Attach the right Handlebar Leg (not shown) to the Right Pedal Arm (not shown) in the same way. See step 7. Tighten the four M8 x 38mm Button Bolts (58). 17 Grease 55 69 92 55 69 14 92 10