ProForm 310 Csx Bike Uk Manual - Page 24

HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the parts described below. Using an adjustable wrench, turn the Right Pedal (26) counterclockwise and remove it. Then, using a standard screwdriver, release the tabs around the edge of the right Access Disc (10), and then remove it from the Right Shield (18). 18 10 26 See assembly step 5 on page 8. Using a standard screwdriver, release the tabs along the bottom edges of the Rear and Front Shield Covers (9, 19), remove the two M4 x 12mm Screws (61), and then remove the Rear and Front Shield Covers. See the EXPLODED DRAWING on page 27. Identify the Left and Right Shields (17, 18). Remove all of the screws from the Left and Right Shields; there are two sizes of screws in the Shields-note which size of screw you remove from each hole. Then, gently remove the Right Shield. Loosen the M6 x 20mm Hex Screw (60). Then, tighten the M10 x 50mm Hex Screw (33) until the Drive Belt (23) is tight. 23 60 33 When the Drive Belt (23) is tight, tighten the M6 x 20mm Hex Screw (60). Then, reattach the parts that you removed. 24