ProForm 380i English Manual - Page 6

3. With the help of a second person, raise the Right Upright (108) and the Left Upright (not shown) to the vertical position. Identify the Right Handrail (72), which has a large hole in the left side. Feed the Wire Harness (42) up into the bracket on the Right Handrail and out of the large hole in the left side. Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the large hole. Insert the bracket on the Right Handrail (72) into the top of the Right Upright (108). Attach the Right Handrail with a 1" Bolt (63) and a Flat Washer (76). Do not tighten the Bolt yet. 4. Attach the Storage Latch (36), with the Latch Spacer (107), to the Left Handrail (71) with two 1" Latch Screws (112). Remove the Lock Knob (30) from the Lock Pin (35). Make sure that the Lock Pin Collar (33) and the Spring (32) are on the Lock Pin as shown. Insert the Lock Pin into the Storage Latch (36) and tighten the Lock Knob back onto the Lock Pin. Attach the Left Handrail (71) to the Left Upright (not shown) as described in step 3. Note: There is not a wire harness on the left side. 5. Set the Crossbar (40) on the brackets on the Handrails (71, 72). Attach the Crossbar with two Crossbar Screws (39). Do not tighten the Crossbar Screws yet. Attach the end of the ground wire to the small hole in the side of the Right Handrail (72) with a Silver Ground Screw (113). 3 42 Large Hole 72 Bracket 63 76 108 4 107 71 30 112 33 36 32 35 5 71 Bracket Ground 113 Wire 39 40 Bracket 39 72 6. Place the Console Base (47) on the Right Handrail (72) 6 and the Left Handrail (not shown). Attach the Console Base with six 3/4" Screws (2) (only four Screws are shown). Do not overtighten the Screws. Insert the Wire Harness (42) through the two indicated plastic ties on the Console Base (47). Next, touch the Right Handrail (72) to discharge any static. Plug the widest connector on the Wire Harness into the widest connector on the back of the Console (43). If the connec- tor does not fit easily, rotate it and then connect it. 2 Plug the other connector on the Wire Harness into the other connector on the Console. 72 If you plan to use iFIT.com CD's or videocassettes, or programs from our Web site (see page 13), plug the Audio Cable (56) into the jack on the back of the Console (43). 6 47 42 Ties 43 2 56