ProForm 385 S English Manual - Page 6

3. Slide a Rubber Ring (74) onto the post on each Upright (14). Refer to the inset drawing. Make sure that each Rubber Ring is turned so the tapered side is facing the thickest part of the post. 3 Post 14 74 Tapered Side Post 74 14 4. Slide the upper end of a Handrail (2) and then the at- 4 tached Extension Leg (41) into the right Upright (14) as shown. (Note: As you insert the Extension Leg, it may be 13 13 helpful to tip the Uprights [14] forward and tap the Extension Leg with a mallet.) Tighten two of the four Handrail Screws (13) into the Handrail. 14 14 2 2 Refer to the inset drawing. Tighten an Extension Leg Screw (34) into the right Upright (14) as shown. Be sure to push on the head of the Extension Leg Screw while tightening it. Attach the other Handrail (2) to the left Upright (14) as described above. 14 34 41 5. With the help of a second person, carefully tip the Uprights (14) down as shown. 5 Tighten the two Handrail Bolts (15) in the Extension Legs (41). Refer to drawing 4. Make sure that the four Handrail Screws (13) are tightened. 15 With the help of a second person, carefully tip the 41 Uprights (14) back to the upright position. 6. Attach the Storage Latch (12) to the left Upright (14) with the Latch Spacer (23) and two Latch Screws (88). Be 6 careful not to overtighten the Latch Screws. 2 15 41 7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor, place a mat under the treadmill. 6 14 14 23 12 88