ProForm 385ex Treadmill Canadian English Manual - Page 10

ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The treadmill walking platform is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. During assembly, refer to the drawings at the right to identify the small parts used in assembly. Assembly requires a phillips screw- driver , an adjustable wrench , and scissors (not included), as well as the included allen wrench . Washer (16)-2 3/4" Screw (59)-4 1/2" Screw (13)-2 Handrail Bolt (15)-2 Extension Leg Screw (34)-4 1. With the help of a second person, carefully raise the Uprights (14), the right Handrail (2), and the Console Base 1 (6) until the treadmill is in the position shown. Be careful not to pull on the Wire Harness (26). Set the Right Handrail on the right Upright until step 3 is completed. Refer to the inset drawing. Insert one of the Extension Legs (41) into the treadmill as shown. (Note: It may be helpful to tip the Uprights (14) in the direction shown by the arrow as you insert the Extension Leg.) Make sure that the Base Pad (36) is on the bottom of the Extension Leg. Attach the Extension Leg with an Extension Leg Screw (34). Be sure to push on the head of the Extension Leg Screw while tightening it. Attach the other Extension Leg (41) in the same way. 2. Cut the plastic ties that hold the cage nuts in each Handrail (2). 2 Position one of the Handrails (2) on the left Upright (14). The lower end of the Left Handrail should be resting against the bracket on the Extension Leg (41) as shown. Thread a Handrail Bolt (15) with a Handrail Washer (16) into the left Upright and Handrail. Do not tighten the Handrail Bolt yet. Make sure that the hole in the bracket on the Extension Leg (41) is aligned with the hole in the Handrail (2). Tighten an Extension Leg Screw (34) into the bracket and Handrail. 6 26 2 14 15 16 14 14 34 41 36 Plastic Tie 2 34 Bracket 41 5