ProForm 440 Es Bike English Manual - Page 9

Tip: Avoid pinching the Main Wire 41.

Get ProForm 440 Es Bike PDF manuals and user guides View all ProForm 440 Es Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

3. With the help of a second person, place some of the packing materials (not shown) under the rear 3 of the Frame (1). Attach the Rear Stabilizer (3) to the Frame (1) with two M10 x 120mm Screws (44); start both Screws, and then tighten them. Then, remove the packing material from under the Frame (1). 3 1 44 4. Have a second person hold the Upright (4) on the Frame (1). Tip: Avoid pinching the Main Wire (41). Attach the Upright (4) with four M10 x 20mm Screws (60); start all the Screws, and then tighten them. Locate the wire tie inside the Upright (4). Tie the lower end of the wire tie to the Main Wire (41). Then, pull the other end of the wire tie upward until the Main Wire is routed through the Upright. Tip: To prevent the Main Wire (41) from falling into the Upright (4), secure it to the Upright with the wire tie. 4 Wire Tie 4 Wire Tie 41 Avoid pinching the Main Wire (41) 60 1 5. Slide the Upright Cover (19) onto the Upright (4) and press it onto the Left and Right Shields 5 (21, 22). 19 4 21, 22 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
9
4
5
19
3
3.
With the help of a second person, place some of
the packing materials (not shown) under the rear
of the Frame (1).
Attach the Rear Stabilizer (3) to the Frame (1)
with two M10 x 120mm Screws (44);
start both
Screws, and then tighten them.
Then, remove the packing material from under
the Frame (1).
1
3
44
4.
Have a second person hold the Upright (4) on
the Frame (1).
Tip: Avoid pinching the Main Wire (41).
Attach
the Upright (4) with four M10 x 20mm Screws
(60);
start all the Screws, and then tighten
them.
Locate the wire tie inside the Upright (4). Tie the
lower end of the wire tie to the Main Wire (41).
Then, pull the other end of the wire tie upward
until the Main Wire is routed through the Upright.
Tip: To prevent the Main Wire (41) from falling
into the Upright (4), secure it to the Upright
with the wire tie.
5.
Slide the Upright Cover (19) onto the Upright
(4) and press it onto the Left and Right Shields
(21, 22).
Wire Tie
Wire Tie
4
4
1
41
60
21, 22
Avoid pinching the
Main Wire (41)