ProForm 505s Treadmill User Manual - Page 7

2. With the help of another person, carefully lower the Uprights (69) as shown. Note: It may be helpful to place one foot on one of the Extension Legs [63] as you tip the Uprights. Make sure that the Extension Legs remain in the Uprights. Attach each Extension Leg (63) with two 1" Tek Screws (39) and a Round Base Pad (57) as shown. Attach the lower Tek Screw, without the Round Base Pad, first. Attach two more Round Base Pads (57) to the base of the Uprights (69) with two 1" Tek Screws (39). Note: One replacement Round Base Pad may be included. If a Round Base Pad becomes worn and needs to be replaced, use the replacement Round Base Pad. Attach the two Wheels (66) with two 2" Bolts (64) and two Wheel Nuts (32) as shown.Do not overtighten the Bolts. The Wheels should be able to spin freely. With the help of another person, carefully raise the Uprights (69) to the vertical position. 3. Identify the Right Handrail (72), which has a large round hole in the location shown. Route the Upright Wire (42) through the hole in the Right Handrail. Press a Handrail Cap (40) onto the lower end of the Right Handrail as shown. Attach the upper end of the Right Handrail to the right Upright (69) with a 2 1/2" Bolt (37). Be careful not to pinch the Upright Wire. Firmly tighten the Bolt. Attach the lower end of the Right Handrail and the Handrail Cap with a 3/4" Tek Screw (58) and a Washer (38). Attach the Left Handrail (71) in the same way. Note: There is not an upright wire on the left side. 2 69 66 64 32 57 39 66 64 39 57 32 57 39 63 57 69 39 63 3 37 71 72 69 Large 42 Hole 37 69 40 38 58 40 38 58 7