ProForm 520 Zlt Instruction Manual - Page 7
Assembly
View all ProForm 520 Zlt manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY • Assembly requires two persons. • To identify small parts, see page 6. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Assembly requires the following tools: the included hex keys one Phillips screwdriver one adjustable wrench To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. 1 Remove and discard the two screws (A) and the shipping bracket (B) from the right side of the Base (74). Then, remove and discard the screws and the shipping bracket (not shown) from the left side of the Base (74). BA 74 2. Locate the Upright Wire (63) bundled between the Base (74) and the Belly Pan (52). Route the 2 Upright Wire into the Base and out of the indi- cated hole. Press a Base Cap (70) into each side of the Base (74). S ee the inset drawing. Cut the plastic tie near the Upright Wire (63). Be careful not to dam- age the Upright Wire. 52 63 Hole Tie Cut 63 74 70 7