ProForm 545s Treadmill English Manual - Page 9

If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 3/4" Screw (6) and the Access Door (94) from the back of the Console Back (95). 2. Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (95). Remove the paper from the adhesive pad on the back of the receiver. Hold the receiver so the small cylinder is near the lower edge of the receiver and is facing the Console Back as shown. Firmly press the receiver onto the indicated corner of the Access Door (94). Note: If there are two screws included with the chest pulse sensor and two plastic posts on the inside of the Access Door, attach the receiver to the plastic posts on the Access Door with the two screws. Wire A Cylinder 95 94 6 3. Make sure that no wires are pinched. Reattach the Access Door (94) with the 3/4" Screw (6). The other wires included with the receiver may be discarded. 9