ProForm 585 Qs Treadmill Canadian English Manual - Page 19
Trouble-shooting
View all ProForm 585 Qs Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
TROUBLE-SHOOTING Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies to your treadmill and follow the steps listed. If further assistance is needed, please call our Customer Service Department at 1-888-936-4266, Mon.-Fri., 8 a.m.-6:30 p.m. EST (excluding holidays). PROBLEM: The power does not turn on SOLUTION: a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 8.) Use only a CUL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length. Important: The treadmill is not compatible with GFCI-equipped outlets. b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in. d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position. c Tripped Reset Tripped d On Position Reset PROBLEM: The power turns off during use SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in. b. Make sure that the power cord is plugged in. c. Remove the key from the console. Reinsert the key fully into the console. d. Make sure that the on/off switch is in the on position. e. If the treadmill still will not run, please call our Customer Service Department, toll-free. PROBLEM: The displays of the console do not function properly SOLUTION: a. Remove the key from the console and unplug the power cord. Remove the screws from the hood and a carefully remove the hood. Locate the Reed Switch 1/8" (21) and the Magnet (43) on the left side of the Pulley 76 42 (42). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between 21 43 the Magnet and the Reed Switch is about 1/8". If necessary, loosen the Reed Switch Screw (76) and Top move the Reed Switch slightly. Retighten the Screw. View Re-attach the hood, and run the treadmill for a few minutes to check for a correct speed reading. PROBLEM: The pulse display on the console does not function properly SOLUTION: a. Wash your hands prior to using the pulse sensor. Clean the sensor with a damp cloth and mild detergent. b. Make sure that there is not a bright light or direct sunlight shining directly on the pulse sensor. 19