ProForm 595le Treadmill English Manual - Page 6

4. While a second person holds the Right Handrail (85) and the Console Base (87) near the right Upright (82), cut the indicated plastic ties off the Right Handrail. Do not cut the other plastic tie off the Right Handrail. Next, cut the plastic tie off the Upright Wire Harness (34) in the right Upright (82). Do not drop the Upright Wire Harness into the right Upright. Refer to the inset drawing. Connect the Upright Wire Harness (34) to the Console Wire Harness (48). The latch on the Console Wire Harness should snap onto the Upright Wire Harness. If the Wire Harnesses do not fit together easily, turn them; do not force the Wire Harnesses together. Next, connect the right pulse wire (with the ÒRÓ tag), the left pulse wire, and the ground wire to the corresponding connectors on the Console Wire Harness (48); make sure that the wires with tags are connected to each other. 4 87 48 Cut Plastic Ties 48 34 Do not cut Right Left Ground 85 34 Cut Plastic Tie 82 5. Note that there is still a plastic tie in the Right Handrail (85); do not remove this plastic tie. Position the Right Handrail (85) on the right Upright (82) as shown. The bracket on the base of the right Upright should be inside of the lower end of the right Handrail, as shown in the inset drawing. While holding the Console Base (87) near the Right Handrail (85), feed the Console Wire Harness (48) into the Right Handrail. Next, place the Console Base on the Handrails (74, 85). Insert any remaining Console Wire Harness into the Right Handrail. Thread two Handrail Bolts (78) with Handrail Washers (36) into the Left Handrail (74) and the left Upright (82) as shown. Do not tighten the Handrail Bolts yet. Next, thread two Handrail Bolts (78) with Handrail Washers (36) into the Right Handrail (85) and the right Upright (82). Do not tighten the Handrail Bolts yet. Be careful to avoid damaging the Console Wire Harness (48). 6. Attach the Console Base (87) to the Left and Right Handrails (74, 85) with four Long Screws (114). Refer to assembly step 5. Tighten the four Handrail Bolts (78) used in assembly step 5. Press two Small Upright Plugs (79) into the holes near the upper ends of the Uprights (82). 7. Remove the backing from the Adhesive Clip (99). Press the Adhesive Clip onto the base of the right Upright (82) as shown. Press the Allen Wrench (100) into the Adhesive Clip. 8. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill. 6 5 78 36 82 87 48 78 36 82 74 Do not Remove this Plastic Tie 85 85 36 6 114 78 87 79 74 82 7 99 Bracket 85 114 82 100