ProForm 60 Gts English Manual - Page 7
Small Screws - treadmill console
View all ProForm 60 Gts manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. With the help of a second person, carefully tip the Uprights (82) back to the vertical position. 3 Attach the Latch Assembly (9) to the left Upright (82) with the two 1/2" Screws (89). 89 9 82 89 4. Insert a Handrail Extension (85) into the post on the left Upright (82). Align the holes in the Handrail Extension with the holes in the post. If necessary, tap the Handrail Extension with a rubber mallet to fully insert it. Next, attach the Handrail Extension by tightening three Small Screws (76) into the indicated holes. Note: If there is only one hole in the top of the post, tighten the third Small Screw into the hole in the left side of the post. Identify the Left Foam Grip (110), which has a large cutout in the right side. Slide the Left Foam Grip as far as possible onto the post on the left Upright (82). It may be helpful to apply soapy water to the Handrail Extension (85). 4 Cutout 110 76 Post 85 76 82 76 5. Make sure that the front edge of the Left Foam Grip (110) is under the Console Base (87) as shown. Tighten 5 a Small Screw (76) into the side of the Left Foam Grip as shown. Note: You may need to pull on the side of the Left Foam Grip to align the Small Screw with the hole in the Upright (82). Attach the Right Foam Grip (not shown) and the other Handrail Extension (not shown) as described in step 4 and this step. Note: Extra screws may be included. 87 76 110 76 6. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 22). To protect the floor or carpet from damage, place a mat under the treadmill.