ProForm 748 Ekg Bike Uk Manual - Page 6
Insert the excess Upper Wire Harness 32 downward
View all ProForm 748 Ekg Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
5. The Console (6) requires four "AA" batteries; alkaline batteries are recommended. Press the tab on the battery cover and remove the battery cover. Insert four batteries into the console; make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Then, reattach the battery cover. Note: The Console (6) can be operated with an optional power supply instead of batteries. To purchase a power supply, call the telephone number on the front cover of this manual. Plug one end of the power supply into the jack on the console. Plug the other end of the power supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. 6. While another person holds the Console (6) near the Upright (3), connect the console wire harness to the Upper Wire Harness (32). Insert the excess Upper Wire Harness (32) downward into the Upright (3). Attach the Console (6) to the Upright with four M4 x 15mm Screws (40). Be careful to avoid pinching the wires. 5 Batteries Battery Cover 6 6 Console Wire Harness 3 40 32 6 Be careful to avoid pinching the wires 40 7. Attach the Handlebar (47) to the Upright (3) with the 7 Upright Clamp (45) and the Adjustment Handle (46). Note: The Adjustment Handle may work like a span- ner. Turn the handle clockwise, push it toward the Handlebar, turn it counterclockwise, pull it away from the Handlebar, and then turn it clockwise again. 47 45 3 46 6