ProForm 750 Rx Uk Manual - Page 7
Handlebar Leg with two M8 x 45mm Button Bolts 50
View all ProForm 750 Rx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
6. Whilst another person holds the Console (23) in the position shown, connect the wire harness on the Console to the Extension Wire Harness (44). Insert the excess wire harness into the Upright Extension (73). Attach the Console (23) to the Upright Extension (73) with three M10 x 27mm Button Screws (67) and three M10 Split Washers (59). Be careful to avoid pinching the wire harnesses. Snap the bookrack onto the Console (23) in the indicated location. 7. Identify the Left Handlebar (6), which is marked with a sticker. Insert the Left Handlebar into one of the Handlebar Legs (5); make sure that the Handlebar Leg is turned so the hexagonal holes are on the indicated side. Attach the Left Handlebar to the Handlebar Leg with two M8 x 45mm Button Bolts (50) and two M8 Nylon Locknuts (38). Make sure that the Nylon Locknuts are inside of the hexagonal holes. Do not fully tighten the Button Bolts yet. Apply a light coat of the included grease to the left axle on the Upright (2) and inside of the two Small Handlebar Bushings (49) in the Left Handlebar (6). Carefully slide an Upright Spacer (48), a Handlebar Spacer (47), the Left Handlebar (6), and a Handlebar Cap (46) onto the left axle on the Upright (2) as shown. Slide a Handlebar Washer (55) onto an M8 x 19mm Button Screw (56), and tighten the Button Screw into the axle. Assemble the Right Handlebar (8) and the other Handlebar Leg (5) in the same way. 6 23 67 59 67 7 Bookrack Wire Harness 44 67 59 73 Grease 8 6 46 55 48 2 47 49 38 56 5 50 Hexagonal Holes 5 8. Identify the left Pedal Spring (11), which is marked with 8 a sticker. Attach the Left Pedal (13) to the left Pedal Spring with an M10 x 27mm Pedal Bolt (80), an M10 Washer (78), and a Pedal Knob (81) as shown. Note: The Left Pedal can be attached in several positions using the five positions in the Left Pedal and the three holes in the Pedal Spring. Attach the Right Pedal (not shown) in the same way. Make sure that both Pedals are in the same hole and in the same pedal position. 80 13 11 78 81 7