ProForm 785pi English Manual - Page 7
Press the Lock Knob Sleeve 70 into the left Upright 69. - treadmill parts
View all ProForm 785pi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Make sure that the Right Foam Grip (75) is flush with the Console Base (82) as shown. Tighten one of the two 4 1 1/4Ó Screws (33) into the side of the Right Foam Grip as shown. Note: It may be necessary to pull the Foam Grip out (see arrow A) to align the Screw with the hole in the post. Attach the Left Foam Grip (not shown) as described in step 3 and this step. Note: There is no plastic tie in the left side. A 82 33 75 5. Press the Lock Knob Sleeve (70) into the left Upright (69). 5 Make sure that the Lock Pin Collar (72) and the Spring (71) are on the Lock Pin. Insert the Lock Pin into the left Upright (69) and tighten the Lock Knob (68) onto the Lock Pin. 68 69 70 71 72 74 6. Look at the Endcap (58). If the left or right foot on the End- cap does not touch the floor, the included thick base pads 6 should be attached to the treadmill as described below. Refer to assembly step 2. Lower the treadmill frame and the Uprights (69) as shown. If the left foot of the Endcap (58) was off the ground, remove the two Base Pads (99) from the right Upright (69). Attach the included thick base pads to the Upright. If the right side of the Endcap was off the ground, attach the thick base pads to the left Upright. If either side of the Endcap (58) lifts off the floor when the treadmill is used, attach the thick base pads as described. Foot 58 Foot 7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet from damage, place a mat under the treadmill. 7