ProForm 785tl English Manual - Page 17
CABLE, Cable
View all ProForm 785tl manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
.gPNNAlP. .01*IgOTI Indoor Antenna 1. Place the VHF antenna in the desired location. Connect the 300 ohm flat wire to the screws on the 300 ohm to 75 ohm adapter. Screwdriver •-•. < 300 Ohm Wire 300 to 75 Ohm AdaetTr FHV 2. Connect the 300 to 75 ohm adapter to the 75 ohm antenna terminal on the treadmill. (See assembly drawing 6 on page 8 for the location of the VHF Rod Antenna 300 to 75 Ohm Adapter 75 Ohm Terminal 2. Push the end of the 300 ohm to 75 ohm adapter into the 75 ohm antenna terminal on the treadmill. (See assembly drawing 6 on page 8 for the location of the terminal.) • 75 Ohm Coaxial Cable Refer to the drawing in the lower left corner of this page. Connect the 75 ohm coaxial cable directly to the 75 ohm antenna terminal on the treadmill. (See assembly drawing 6 on page 8 for the location of the terminal.) CATV CABLE CONNzEG ON # ... .. 1. Remove the VHF 300 to 75 ohm adapter or the VHF cable from the antenna terminal. 2. Connect the CATV cable (75 ohm coaxial cable) to the 75 ohm antenna terminal on the treadmill. (See assembly drawing 6 on page 8 for the location of the terminal.) 75 Ohm CATV Cable Outdoor Antenna Outdoor antennas are subject to weathering that can reduce signal quality. Inspect the antenna and lead-in wiring before connecting the antenna. Any service center can explain the various outdoor antennas available. Combination VHF/UHF Antennas ]*: Read the important precautions on pages 2 to 5 of this manual. Before operat- ing the TV, make sure that the on/off switch located on the front of the motor hood is in the "on" position, and that the "On" Position power cord is properly plugged in (see page 9). 300 Ohm Flat Wire 300 to75 Ohm Adapter 75 Ohm Terminal on Treadmill 75 Ohm Coaxial Cable 75 Ohm CATV Cable • 300 Ohm Flat Wire 1. Refer to the drawing above. Connect the 300 ohm flat wire to the 300 ohm to 75 ohm adapter. Battery Installation Before the remote control can be operated, two "AAA" Remote Control batteries (included) must be installed. Slide the battery cover off the back of the remote con- trol. Press two batteries into the re- • iii • mote control. Make sure that the batteries are turned "AAA" Batteries as shown. Reattach the battery cover. Battery Cover 17