ProForm Crosswalk 300 Treadmill English Manual - Page 8

5. With the help of a second person, carefully tip the treadmill onto its right side. Partially fold the Frame (48) so the treadmill is more stable; do not fully fold the Frame yet. Remove and discard the two indicated bolts (A) and the shipping bracket (B). Attach a Base Pad (81) to the Base (85) as shown with a Base Pad Spacer (104) and an M4 x 25mm Screw (2). Then, attach another Base Pad (81) with only an M4 x 25mm Screw (2). Remove the M10 Nut (33), the M10 x 50mm Bolt (27), and the shipping bracket (C) from the Base (85). Attach a Wheel (86) with the Bolt and the Nut that you just removed. Do not overtighten the Nut; the Wheel must turn freely. Discard the shipping bracket. 5 A 81 2 B 85 48 27 104 86 2 81 C 33 6. With the help of a second person, hold a Bolt Spacer (79) inside the lower end of the Left Upright (73). Insert an M10 x 96mm Bolt (5) with an M10 Star Washer (8) into the Left Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (79), M10 x 96mm Bolt (5), and M10 Star Washer (8). Orient the Left Upright (73) and the Left Upright Spacer (83) as shown. Hold the Left Upright Spacer and the Left Upright against the Base (85). Finger tighten the M10 x 96mm Bolts (5); do not fully tighten the Bolts yet. Press a Base Endcap (82) into the Base (85). With the help of a second person, tip the treadmill so that the Base (85) is flat on the floor. 6 5 8 79 79 82 85 7. Set the Console (87) face down on a soft surface to avoid scratching the console assembly. Identify the Right Handrail (90), which has a large hole in the location shown. Hold the Right Handrail near the Console. Attach the console ground wire to the Right Handrail with a #8 x 1/2" Screw (22). Next, insert the console wire into the large hole in the bottom of the Right Handrail and out of the top as shown. If necessary, use needlenose pliers to help pull the console wire out. Attach the Right Handrail (90) and the Left Handrail (not shown) with six M4 x 19mm Screws (1) (only one side is shown). Make sure that no wires are pinched. Start all six Screws before tightening any of them; do not overtighten the Screws. 7 90 1 Console Ground Wire 22 87 8 73 83 Console Wire Large Hole 1