ProForm Crosswalk 415 Treadmill English Manual - Page 6
Assembly - used
View all ProForm Crosswalk 415 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Make sure that the power cord is unplugged. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex keys , your own Phillips screwdriver adjustable wrench . , and an Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. Extra hardware may be included. If a part is missing, call 1-888-533-1333. To avoid damaging plastic parts, do not use power tools for assembly. M8 Star Washer (10)-4 M10 Star Washer (8)-8 Base Pad Spacer (104)-2 M4 x 13mm Screw (3)-1 M4 x 25mm Screw (2)-4 M4 x 19mm Screw (1)-6 M8 x 25mm Bolt (6)-4 1/4" Washer (9)-4 1/4" x 3 1/2" Bolt (4)-4 Bolt Spacer (79)-4 M10 x 96mm Bolt (5)-4 1. Make sure that the power cord is unplugged. 1 With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (48) so that the treadmill is more stable; do not fully fold the Frame yet. B Tie 77 Remove and discard the two indicated bolts (A) and the shipping bracket (B). Cut the tie securing the Upright Wire (77) to the Base (85). Locate the tie in the indicated hole in the Base, and use the tie to pull the Upright Wire out of the hole. Attach a Base Pad (81) to the Base (85) in the location shown with a Base Pad Spacer (104) and an M4 x 25mm Screw (2). Then, attach another Base Pad with only a Screw. 48 6 85 104 81 2 A Hole 81 2