ProForm Crosswalk Advanced 525x Treadmill English Manual - Page 7

3. With the help of a second person, carefully tip the Uprights (64) back to the vertical position. 3 115 32 Attach the Latch Assembly (32) to the left Upright (64) with two Latch Screws (115). Note: The two Latch Screws may be in the Left Upright (64). 64 115 4. Orient one of the Handgrip Extensions (34) so the bottom is open as shown, and insert it as far as possible into the post on the left Upright (64). If necessary, tap the Handgrip Extension with a rubber mallet to fully insert it. Attach the Handgrip Extension with two Extension Screws (35), one towards the front of the post, and the other towards the back. Attach the other Handgrip Extension to the post on the right Upright (not shown) in the same way. 4 Post 35 34 64 Open side 5. See the inset drawing. Identify the Left Top Handgrip (31); there are identifying marks inside of the Handgrips. Set the Left Top Handgrip on the left Handgrip Extension (34). Insert two 1/2" Screws (33) into the two holes in the Handgrip Extension indicated by the arrows. Tighten the Screws into the Left Top Handgrip. Important: Do not insert the two 1/2" Screws (33) into the wrong holes in the Handgrip Extension (34), or tighten the Screws into the plastic bosses on the bottom of the Left Top Handgrip (31). 5 31 Bosses 33 34 64 33 35 35 31 43 6. Attach the matching Left Bottom Handgrip (104) with 6 three 1/2" Screws (33). Attach the Right Top Handgrip and the Right Bottom Handgrip (not shown) as described above. Remove the plastic ties from the Upper Body Arms (not shown). 33 104 33 7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 25). To protect the floor or carpet from damage, place a mat under the treadmill. 7