ProForm Endurance 920 E Elliptical English Manual - Page 36
Maintenance And Troubleshooting
View all ProForm Endurance 920 E Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
MAINTENANCE AND TROUBLESHOOTING MAINTENANCE HOW TO ADJUST THE REED SWITCH Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the elliptical is used. Replace any worn parts immediately. If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first press the power switch to the off position and unplug the power cord. To clean the elliptical, use a damp cloth and a small Next, use amount of mild soap. IMPORTANT: To avoid damage a standard to the console, keep liquids away from the console screwdriver to and keep the console out of direct sunlight. remove the left Disc (71). CONSOLE TROUBLESHOOTING 71 If the console does not turn on, make sure that the power cord is fully plugged in. If the console does not display your heart rate when you hold the handgrip heart rate monitor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 25. Note: For clarity, the left shield and the left disc ring are shown removed in the drawing below. If the console does not display your heart rate when you use the chest heart rate monitor, see TROUBLESHOOTING on page 18. Locate the Reed Switch (38). Turn the Pulley (19) until a Magnet (43) is aligned with the Reed Switch. INCLINE SYSTEM TROUBLESHOOTING If the ramp does not move to the correct incline level, 19 see step 4 on page 32 and calibrate the incline system. 38 43 101 Next, loosen, but do not remove, the indicated M4 x 16mm Screw (101). Then, slide the Reed Switch (38) slightly closer to or away from the Magnet (43), and retighten the Screw. 36