ProForm Lx450 Treadmill English Manual - Page 7

2. Identify the Right Upright (24) and the Left Upright (99). Straighten the Upright Wire (42), and feed it into the lower end of the Right Upright (24) and out of the upper end. Next, hold the Right Upright against the right side of the Base (69); make sure that the Right Upright is turned so that the upper end is angled in the direction shown. Hand tighten two 3" Bolts (37) with one Star Washer (63) and two Washers (45) into the Base and the Right Upright; be careful not to damage the Upright Wire. With the help of a second person, carefully tip the treadmill onto its other side. Attach the Left Upright (99) and the other Wheel (not shown) as described above and in step 1. Make sure that the two small holes in the Left Upright are positioned as shown. Note: There is not an upright wire on the left side. 2 42 24 69 63 37 45 Small Holes 99 3. With the help of a second person, carefully tip the treadmill so that it is flat on the floor, and raise the Uprights (99, 24) to the vertical position as shown. Hold the Crossbar (25) between the Left Upright (99) and the Right Upright (24). Attach the Crossbar with two 3" Bolts (37). Firmly tighten the Bolts. Identify the Right Handrail (72), which has a large round hole in the location shown. Route the Upright Wire (42) through the hole in the Right Handrail. Next, hand tighten a 2 1/4" Bolt (35) into the upper end of the Right Handrail and the Right Upright (24). Then, hand tighten a Handrail Bolt (27) with a Washer (45) into the lower end of the Right Handrail and the Right Upright. Be careful not to pinch the Upright Wire. Firmly tighten the Bolts. Attach the Left Handrail (71) in the same way. Note: There is not an upright wire on the left side. 3 35 37 71 72 25 Large 42 Hole 99 35 37 45 27 24 45 27 7