ProForm Performance 650 Treadmill Uk Manual - Page 16

4. Change the incline of the treadmill as desired. To change the incline of the treadmill, press the Incline increase or decrease button or one of the Quick % Grade buttons numbered 0 through 10. Each time you press one of the buttons, the treadmill will gradually adjust to the selected incline setting. 5. Follow your progress with the displays.  When the manual mode is se- lected, the upper half of the display Track will show a track that represents 400 m (1/4 mile). As you walk or run, indicators will appear in succession around the track until the entire track appears. The track will then disappear and the indicators will again begin to appear in succession. The upper half of the display can also show the elapsed time, the distance you have walked or run, the speed of the walking belt, the approximate number of calories you have burned, your pace in minutes per kilometer, and the incline of the treadmill. Press the Priority Display button repeatedly until the desired workout information appears. The lower left corner of the display will show the elapsed time, the distance that you have walked or run, and the incline level of the treadmill. Note: When an onboard workout is selected, the display will show the time remaining in the workout instead of the elapsed time. The lower right corner of the display will show the approximate number of calories you have burned, the speed of the walking belt, and your pace in minutes per kilometer. The right side of the display will also show your heart rate when you use the handgrip heart rate monitor. To reset the display, press the Stop button, remove the key, and then reinsert the key. 6. Measure your heart rate if desired. Before using the handgrip heart rate monitor, remove the sheets of plastic from the metal contacts. In addition, make sure that your hands are clean. Contacts To measure your heart rate, stand on the foot rails and place your hands on the metal contacts- avoid moving your hands. When your pulse is detected, the heart symbol in the display will begin to flash each time your heart beats, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for at least 15 seconds. 7. When you are finished exercising, remove the key from the console. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting or you may damage the treadmill when you fold it to the storage position. Next, remove the key from the console and put it in a secure place. When you are finished using the treadmill, press the power switch into the off position and unplug the power cord. IMPORTANT: If you do not do this, the treadmill's electrical components may wear prematurely. 16