ProForm Style 9000 Uk Manual - Page 10
Identify the Gas Spring 99. Note that the Gas
View all ProForm Style 9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10. Have a second person raise and hold the treadmill Frame (74). Identify the Gas Spring (99). Note that the Gas Spring has a cylinder end and a rod end. See the two small inset drawings. Locate the Gas Spring Clip (98) in the rod end of the Gas Spring. Using your fingernail or the end of a screwdriver, press on the end of the Spring Clip to loosen it, rotate the Gas Spring Clip, and then pull the Gas Spring Clip out of the Gas Spring. Be careful to avoid losing the Gas Spring Clip. Note: Extra Gas Spring Clips are included. Next, hold the rod end of the Gas Spring (99) near the bracket in the center of the Frame (74). Press the end of the Gas Spring as far as possible onto the ball on the bracket. See the large inset drawing. Insert the Gas Spring Clip (98) into the two indicated small holes in the rod end of the Gas Spring (99). Then, rotate the Gas Spring Clip until it clips onto the Gas Spring. 10 Cylinder 99 74 Rod Bracket 98 74 99 98 Holes 98 98 Bracket 11. Pivot the cylinder end of the Gas Spring (99) down to the position shown. Remove the Gas Spring Clip (98) from the end of the Gas Spring. Next, align the cylinder end of the Gas Spring (99) with the bracket in the center of the Base (48). Press the end of the Gas Spring onto the ball on the bracket. Note: It may be necessary to pivot the Frame (not shown) forward or backward slightly to align the end of the Gas Spring with the ball. See the inset drawing. Insert the Gas Spring Clip (98) into the two indicated small holes in the Gas Spring (99). Then, rotate the Gas Spring Clip until it clips onto the Gas Spring. With the help of a second person, lower the Frame (not shown) to the floor. 11 48 98 99 Bracket 99 48 98 Holes Bracket 10