Pyle HTG138 Instruction Manual - Page 5
Panel Layout
 |
View all Pyle HTG138 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
PANEL LAYOUT Front View Rear View CONTROL FUNCTIONS 1. RCA input jacks These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system. 2. GAIN Control The level control will match the ampli ers sensitivity to the source units signal voltage. The Operating range is 200mV minimum to 6V maximum. CAUTION: Do not run the ampli er in high volume for long time, otherwise the loudspeakers will be damaged. 3. SUBSONIC The frequency can be adjusted between 0Hz and 80Hz. www.Lanzar.com 5
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12
 |
 |
www.Lanzar.com
5
PANEL LAYOUT
Front View
Rear View
CONTROL FUNCTIONS
1.
RCA input jacks
These RCA input jacks are for use with source units that have RCA or Line level
outputs. A source unit with a minimum level of 200mV is required for proper
operation. The use of high quality twisted pair cables is recommended to
decrease the possibility of radiated noise entering the system.
2.
GAIN Control
The level control will match the amplifiers sensitivity to the source units signal
voltage. The Operating range is 200mV minimum to 6V maximum.
CAUTION:
Do not run the amplifier in high volume for long time, otherwise
the loudspeakers will be damaged.
3.
SUBSONIC
The frequency can be adjusted between 0Hz and 80Hz.