Pyle HTG559BT Instruction Manual - Page 4
Wiring Connection
View all Pyle HTG559BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
WIRING CONNECTION 1. Ground: To Vehicle Chassis To avoid unwanted ignition noise caused by ground loop, it is essential that the Ampli er be grounded to a clean, bare, metal surface of the vehicle's Chassis NOTE: GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT. (1 METER). 2. +12 Volt (Fused) Constant Power: To Battery (+) Due to the power requirements of the Ampli er, this connection should be made directly to the positive (+) terminal of battery. For safety measures, install an in-line Fuse Holder (not included) as close to the battery positive (+) terminal as possible with an ampere rating; not to exceed total value of fuses in Amp. 3. Remote Turn-On Input: To remote turn-on output of Car Stereo This Ampli er is turned "ON" remotely when the vehicle's stereo is turned "ON". NOTE: IF YOUR RADIO DOES NOT HAVEA +12 VOLT OUTPUT LEAD WHEN THE RADIO IS TURNED ONɼTHE "REMOTE" TERMINAL ON THE AMPLIFIER CAN BE CONNECTED TO VEHICLE'S ACCESSORY CIRCUIT THAT IS LIVE WHEN THE KEY lS "ON". HTG559BT - HTG669BT 4 www.Lanzar.com