Pyle PRJ3D69 PRJ3D69 Manual 1 - Page 6

Hfwlrq µ 8vlqj Wkh Uhprwh Frqwuro, Qvhuwlqj Edwwhulhv, 1rwlfh²

Get Pyle PRJ3D69 PDF manuals and user guides View all Pyle PRJ3D69 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

&RQQHFWLQJDFRPSXWHU Please turn off the power of the projector and signal before connecting a VGA source while the power is on may result in operational errors. Please confirm the type of connector fits the input on the projector, the projector can be damaged if the wrong connector is inserted. Set projector to the "VGA" by using the button "PC/ AV". Refer to the VGA source manual to configure the source resolution and frequency. &RQQHFWLQJ$XGLR9LGHR6RXUFHV Connect audio and video output sources to the corresponding input connections located on the side of the projector. 1RWLFH To select the AV source use the mode button on supplied remote or press the PC/AV button located on the top of the projector until AV is select. Video output and left/right audio output of signal source should connect with corresponding input ports located on the side of the projector. 6HFWLRQ8VLQJWKHUHPRWHFRQWURO ,QVHUWLQJEDWWHULHV 1. Remove the rear cover 2. Load the batteries as indicated by the marks in the battery compartment . 3. Put the rear cover back on 1RWLFH 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
compartment .
with corresponding input ports located on the side of the projector.
the PC/AV button located on the top of the projector until
AV is select.
To select the AV source use the mode button on supplied remote or press
connector fits the inpu
Please confirm the type of
VGA source while the power is on may result in operational errors.
Please turn off the power of the projector and signal before connecting a
Video output and left/right audio output of signal source should connect
1RWLFH²
&RQQHFWLQJ $XGLR 9LGHR 6RXUFHV
connections located on the side of the projector.
Connect
audio and video output sources to the corresponding
input
frequency.
Refer to the VGA source manual to configure the source resolution and
5
&RQQHFWLQJ D FRPSXWHU
t on the projector, the
projector can be damaged if the wrong connector is inserted.
Set projector to the “VGA” by using the button “PC/ AV”.
6HFWLRQ µ 8VLQJ WKH UHPRWH FRQWURO
,QVHUWLQJ EDWWHULHV
1.
Remove the rear cover
2. Load the batteries as indicated by the marks in the battery
3.
Put the rear cover back on
1RWLFH²