RCA RP5050 User Manual - RP5050 - Page 15

RP5050 EN 18/10/06 11:16 AM Page 16 Setting AVR 5. Press to enter AVR mode. You can select between two "AVR" will be displayed. EN recording modes - manual recording 6. During AVR on and AVR (Automatic Voice recording, you can Recording). Default AVR setting is off also adjust the and the AVR Level is 5. sensitivity of the microphone from AVR (Automatic Voice Recording) This feature allows the player to sense sound and to record only when you are speaking into the microphone. When dictation stops for about 3 seconds, recording will stop and then start again automatically when you resume level 1 to 8 by pressing or . The AVR value displays . 7. Start dictation. Recording starts automatically. 8. Press to end AVR recording. 9. Repeat step 2-4 and select AVR off for de-selection. dictation. AVR Level You can adjust the AVR value before recording. Tip: The first syllable or two may be lost when you start recording because this 'sound' is used to turn on the AVR feature. It is a good practice to make some 'sounds' or say a short word to activate the AVR before you begin actual dictation. AVR Setting 1. In Main Menu Mode, press or to select Record Menu and press to confirm your selection. 2. Press or to select AVR and press to confirm your selection. 3. Press or to toggle between On and Off. 4. Press or MENU to save and exit the current option. 1. In Main Menu Mode, press or to select Record Menu and press to confirm your selection. 2. Press or to select AVR Level and press to confirm your selection. 3. Press or to adjust the sensitivity of the microphone from level 1 to 8. 4. Press to enter AVR mode Start dictation. Recording starts automatically. Note: Decrease the AVR value and thus the sensitivity when the recording environment is noisy and vice versa. 12