Reebok 190rs English Manual - Page 19
Trouble-shooting
View all Reebok 190rs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
TROUBLE-SHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department tollfree at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). PROBLEM: The power does not turn on SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps. Important: The treadmill is not compatible with GFCI-equipped outlets. b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in. c Tripped Reset d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position. PROBLEM: The power turns off during use d On Position SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in. b. Make sure that the power cord is plugged in. c. Unplug the power cord, wait for five minutes, and then plug the power cord back in. d. Remove the key from the console. Reinsert the key fully into the console. e. Make sure that the on/off switch is in the on position. f. If the treadmill still will not run, please call our Customer Service Department, toll-free. PROBLEM: The displays of the console do not function properly SOLUTION: a. Remove the key from the console and unplug the power cord. Remove the screws from the hood and a carefully remove the hood. Locate the Reed Switch 1/8" (21) and the Magnet (43) on the left side of the Pulley 76 42 (42). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between 21 43 the Magnet and the Reed Switch is about 1/8". If necessary, loosen the Reed Switch Screw (76) and Top move the Reed Switch slightly. Retighten the Screw. View Re-attach the hood, and run the treadmill for a few minutes to check for a correct speed reading. PROBLEM: The CALS/FAT CALS/PULSE display on the console does display your heart rate SOLUTION: a. Wash your hands before using the pulse sensor. Clean the sensor with a damp cloth and mild detergent. b. Make sure that there is not a bright light or direct sunlight shining directly on the pulse sensor. 19