Reebok Rbx 600 English Manual - Page 30

PROBLEM: The displays and indicators on the console remain lit after the key is removed SOLUTION: a. Hold down the STOP button while inserting the key into the console. a Make sure that there is not a letter ÒdÓ in the CALS/FAT CALS display. If a ÒdÓ appears in the display, the console is in the ÒdemoÓ mode. This mode is intended to be used only when a treadmill is dis- played in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the displays and indicators on the console will automatically light in a preset sequence, although the buttons on the console will not operate. If a ÒdÓ appears in the CALS/FAT CALS display, press the SPEED Ð button so the display is blank. Then, remove the key from the console. PROBLEM: The displays of the console do not function properly SOLUTION: a. Remove the key from the console and unplug the power cord. Next, remove the two Short Hood Screws (118) from the Motor Hood (62). Pivot the Uprights (39) in the direction shown by the arrow until the handles are resting on the floor. Note: It will be easier and safer if two people perform this operation. Locate the two Screws (41) in the space between the front edge of the Motor Hood (62) and the treadmill. Remove the Screws. a 118 39 62 41 118 Return the Uprights (39) to the vertical position. Lift off the Motor Hood (62), being careful not to damage the hook and loop fasteners on the front of the belly pan. Locate the Reed Switch (59) and the Magnet (117) on the left side of the Pulley (6). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8Ó. If necessary, loosen the Screw (64) and move the Reed Switch slightly. Retighten the Screw. Re-attach the Motor Hood (62) and run the treadmill for a few minutes to check for a correct speed reading. 1/8Ó 64 59 Top View 6 117 30