Reebok Rtx455 English Manual - Page 8
If you purchase the optional chest pulse sensor see follow the steps below to install
View all Reebok Rtx455 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated Screws (87) from the back of the Console 1 Base (88). 88 87 2. Connect the Short Jumper Wire (A) to the wire on the Receiver (B). Connect the other end of the Jumper Wire to the PULSE jack on the back of the Console (see drawing 2b). Next, peel the paper off the pad on the bottom of the Receiver (B). Turn the Receiver so the cylinder is on the side shown, and press the Receiver into the bottom of the Console Base (81) in the location indicated by the dotted line. Note: The included Long Jumper Wire is not needed and can be discarded. Make sure that no wires are pinched. Reattach the back of the Console Base (88) with the Screws (87) (see step 1 above). 2a 81 A Cylinder B 2b PULSE Jack 8