Ricoh 5100N User's Guide - Page 111
Windows 98/Me, Test Print
UPC - 026649028502
View all Ricoh 5100N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
3 Enter the IP Address of the printer in the [Name or address of server providing lpd] field. Enter [lp] (in lower case) in the [Name of printer or print queue on that server] field. Note: lp must be entered regardless of the name of the printer or print queue. lp is the name of the remote printer/ server on the printer. This name does not change. Select [OK]. Select [Close]. 4 With the New Port selected, select [Next]. Insert the CD ROM with the printer drivers into the workstation and select [Have Disk]. Browse to the required Windows NT driver on the CD ROM and select [OK]. Note: The driver will be found in the Print folder on the CD in the appropriate PCL folder. The driver is identified by the file extension .inf. Select [Next], and select [Next] again and the printer driver will be loaded onto the workstation. 5 Enter the Printer Name and select [Next]. Select [Shared], if you want to share. Otherwise, just select [Next]. A dialog box will be displayed with a message regarding the printing of a test page. Select [Finish] to accept the Yes choice. 6 Continue with Test Print. Windows 98/Me 1 Refer to "Installing Printer Software for Network Printing" Software Section "User's Guide" to install and setup the printer drivers on the workstation. Once the drivers are installed, connect a driver to the printer on the network by selecting [ Multi Direct Print Type S] for the network port. 1. Select [Start], select [Settings], and then select [Printers]. Right-click on the installed Printer icon and select [Properties]. 2. Select [Details] tab, and Click [Add Port]. The [Add Port] screen will be displayed. 3. Select [Other] Radio button. Select [Multi Direct Print Type S], and then click [OK]. 4. Search a printer using the following radio button options and click [Next]. - IP Address - IPX/SPX Address - DNS Name - Auto detection on the network 5. If you select "Auto detection on the network" in the step 4, printers on the network are listed up. Select a printer in the list and click [Next]. Other options in the step 4 skip this step. 6. Insert port name and click [Finish]. 2 Continue with Test Print. Test Print To ensure the printer has been installed on the network correctly a test print should be submitted from a client workstation. Perform the following steps: 1 Open a document on a client workstation. 2 Select the SP 5100N as the printer for sending documents to. 3 Print the document on the device and verify that it prints correctly. 4 Ensure the print driver is installed on every workstation that will be sending jobs to the device. 5 Repeat the test for all workstations that will be sending jobs to the device. 3.3 Print Driver Installation for Networked Printers