Ricoh GX3050SFN User Guide - Page 29
Non-compatible Paper
UPC - 026649055515
View all Ricoh GX3050SFN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Paper z Only one-sided printing is possible. z Remove sheets from the output tray individually, as they come out. z Before handling, make sure printed sheets have fully dried. z If you want to stack prints soon after they are printed, we recommend inserting a moisture-absorbent sheet, like copy paper, between prints. z Ink takes time to dry. To prevent sheets from sticking together, remove them from the output tray individ- ually, as they come out. z If printing comes out streaked, adjust the paper feed level.. z Use at 15-25°C (59-77°F) and 30-70% humidity. z Use as soon as possible after opening the package. z When using these sheets, see the instructions supplied with them. Envelopes z Up to 20 envelopes can be loaded in tray 1. z If the envelopes bulge, flatten them. z Load envelopes carefully, because the printable area depends on the orientation. z Set the lever to the rear position before printing. Thick paper z Use tray 1 to load paper lighter than 157 g/m2 (297.6 lb.). z You can insert paper with weights up to 255 g/m2 (485.0 lb.) into the bypass tray. z Insert paper with the print side face up into the bypass tray. Cautions to Observe After Printing Depending on the paper type, the ink may take a while to dry. Before handling, make sure printed sheets have fully dried. otherwise, the ink may smudge. z The ink may smear depending on the type of image. If this happens, set the envelope selector to the rear position . Non-compatible Paper Check if the paper is compatible. Do not use paper that is: z wrinkled, folded, or damaged z wavy at the ends z curled z absorbent z dry and conducive to static buildup z already printed on (such as the back of preprinted paper) z preprinted (unless specified) z heat sensitive/non-carbon z too thick or thin z pre-stitched z glued or tacked 29