Ricoh MP7040A User Guide - Page 12

MP 7040A Series 3. Installing the Drive 3.1 Before Installation Before installing the drive, please note the following points. z your will need the following: • A Phillips head screw driver of a suitable size to fit the securing screws for the drive unit. • The manual for the computer, so you can find out the positions for the IDE controller. z Turn off all peripheral appliances of the computer, and the computer itself , and disconnect their power cords from the wall sockets. z Discharge any static electricity by touching the computer covers etc. z Record the serial number of the drive unit in the box below. Serial No. 3.2 Jumper Set Up Before installation, set the jumper on the jumper connector on the rear panel. The drive can be connected as the Master or Slave on an EIDE (ATAPI) interface. When several (up to four) EIDE devices are connected, each must be set in a unique way. Specific knowledge of hardware and software is necessary to install the drive. We cannot guaranty against direct or indirect damage resulting from improper connections. Ask your supplier for details of the installation procedure. If two peripheral devices with the same settings are both connected to the Primary or to the Secondary EIDE bus, the host computer may fail to run, or may malfunction, so careful attention is necessary. CS: Cable Select (CSEL) SL: Slave MA: Master 5