Ricoh P 311 Firmware Update Guide - Page 17
USB Upload : End of data
View all Ricoh P 311 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Troubleshooting Message Machine is not ready. Check that the machine is properly connected to the network. Net Upload : FAIL USB Upload : End of data Causes Solutions The USB cable is not connected. Make sure the USB connection between the machine and computer is secure. If this message persists, try another USB cable. The USB printer driver is not installed in your computer. Install the USB printer driver in your computer. The machine is turned off or an error has occurred. Turn the machine's power off, wait a moment, and then turn it back on again. Then perform the update again. If this message reappears after you turn the power back on, see the manuals provided with the machine. The IP address specified for either Check that both IP addresses are the machine or your computer is valid. invalid. The machine is not connected to the network properly. Check that the machine is properly connected to the network. The firmware has been transferred to the machine successfully. Follow the instructions in this manual to complete the update. The network cable was disconnected immediately after the [Firmware Update (LAN)] button was clicked. Turn the machine's power off, wait a moment, and then turn it back on again. Disconnect any unnecessary cables from the machine, and then try again. The firmware has been transferred to the machine successfully. Follow the instructions in this manual to complete the update. 15