Rocketfish RF-ANT50UD Quick Setup Guide
Rocketfish RF-ANT50UD Manual
 |
View all Rocketfish RF-ANT50UD manuals
Add to My Manuals
Save this manual to your list of manuals |
Rocketfish RF-ANT50UD manual content summary:
- Rocketfish RF-ANT50UD | Quick Setup Guide - Page 1
drill bit to drill six holes that are 1.8 in. deep, then clean the holes. Wall QUICK SETUP GUIDE RF-ANT50UD, Long-range Outdoor Antenna 3 Use a hammer to insert the wall anchors (6) into the holes, then attach Before using your new product, please read these instructions to prevent any damage. - Rocketfish RF-ANT50UD | Quick Setup Guide - Page 2
manual to check compatibility. • The antenna's range will vary depending on a wide range of environmental and geographic factors-the mile range provided is only for reference. TROUBLESHOOTING PROBLEM ROCKETFISH: For customer service call 1-800-620-2790 www.rocketfishproducts.com ROCKETFISH is
-
1 -
2
 |
 |
PACKAGE CONTENTS
• Digital outdoor antenna
• Power inserter
• Coaxial cable
• AC Adapter
•
Installations kits for wall and pole mounting
•
Quick Setup Guide
WARNING: INSTALLATION OF THIS PRODUCT NEAR POWER LINES
IS DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION
DIRECTIONS.
MOUNTING TOOLS
If mounting to a wall, roof, or another surface, you'll need a:
•
Drill with 5/16" drill bit
•
Hammer
•
Phillips screwdriver
•
Pen or pencil
FEATURES
•
60-mile range for superior reception, even in difficult locations
•
Amplifier included to boost weak signals from far away
•
Designed for outdoor use—resistant to summer and winter elements
•
Full kit of installation parts included for mounting to exterior walls, roofs, attics, poles, or
other surfaces
•
Works with 4K TVs
MOUNTING YOUR ANTENNA
Stationary Installation
1
Use the base plate to mark the drilling positions.
2
Use an electric drill with a 5/16" drill bit to drill four holes that are 1.8 in. deep, then clean the
holes.
3
Use a hammer to insert the wall anchors (6) into the holes, then attach the pedestal to the
wall with the large screws (6).
4
Place th
e stand tube into the pedestal, then adjust its position and attach with the
screws (2) and hex nuts (2).
3
Use a hammer to insert the wall anchors (4) into the holes, then attach the base plate to the
wall with the large screws (4).
4
Place the antenna on the base plate, then fasten with the plastic cap screws (4).
QUICK SETUP GUIDE
RF-ANT50UD,
Long-range Outdoor Antenna
Before using your new product, please read these instructions to prevent any damage.
Flexible Installation
1
Use the pedestal to mark the drilling positions.
2
Use an electric
drill with a 5/16" drill bit to drill six holes that are 1.8 in. deep, then clean the
holes.
5
Attach the base plate to the stand tube with U bolts (2), washers (4), and wing nuts (4).
6
Place the antenna on the base plate, then fasten with the plastic cap screws (4).
Stand tube
Pedestal
Wall
Wall
Wall
Wall
Pedestal
Wall
Pedestal
Wall
Wall
Base plate
Wall
Base plate
Antenna
Plastic cap
screws
Base plate
Wing nuts
Stand tube
U bolts
Antenna
Plastic cap
screws
Wall
Base plate